Can uncoated paper stock be written on with pen, pencil, or marker? Uncoated cover takes pencil, pen and marker without beading or smearing, and both 13pt and 14pt work for writing, with 14pt slightly thicker… Read answer Can I write on velvet laminated cards with pen or marker? Yes. Velvet laminated cards accept both ballpoint pen and permanent marker, though results can vary with the specific piece and how it is ha… Read answer How do saddle-stitched booklets work and what does 'flat size' vs. 'folded size' mean? Saddle-stitched booklets nest folded sheets stapled at the spine, so pages come in multiples of four, and the flat size is the full open she… Read answer What does '4/0' mean when you quote printing on magnets or other products? In a 4/0 spec, the first number is the front and the second the back, with 4 meaning full CMYK color, so 4/0 prints the front and leaves the… Read answer What is the metric equivalent for magnet thickness measurements in points? One point equals one-thousandth of an inch, so divide points by 1000 for inches and multiply by 25.4 for millimeters, making 30PT about 0.76… Read answer What is a lanyard slot? A lanyard slot is a punched hole in a badge or card that gives you a place to attach a hook, clip, or cord so the piece can hang from a lany… Read answer Do laminated badges need a plastic sleeve or can they connect directly to lanyards? Laminated badges already carry plastic film on both sides, so they skip the sleeve and attach straight to a lanyard through a punched slot o… Read answer What file specifications should I use for custom event badges? Build event badge art to the exact ordered size, such as 3" x 5" for a 3" x 5" badge, and say which dimension is fixed if both cannot be met… Read answer What file specifications are required for lenticular printing? Lenticular files need the number of flips and the effect direction stated so the lens is oriented right, since the moving effect needs preci… Read answer Do I need to include bleed in my print file for a car magnet? Car magnets with edge-to-edge art need 0.125" bleed on all four sides so no white border shows after cutting, and key text should sit 0.125"… Read answer What is dry erase lamination and can it be applied to magnets? Dry erase lamination can go on magnets as a clear front coating, turning the print into a write-and-wipe surface for calendars and meal plan… Read answer What file setup is needed for UV spot printing on cards? UV spot cards need separate files per side: Front and Front UV, then Back and Back UV, each UV layer marking exactly where the raised gloss … Read answer
Didn't find your answer?
Our team replies within 24 hours.
